Will roof sand grit clog the stainless steel micromesh holes?

Our highly tested field results have shown more than 99% of the time, small roof sand grit will NOT clog the mesh. An area where there may be some accumulation of shingle grit is with inside corners. Occasionally, there is some accumulation of small debris and grit which might collect near the bottom of a roof valley. It is therefore recommended to brush off this area from time to time.

Will pollen, pine needles or dirt clog the stainless steel micromesh holes?

LeafBusters® Installed gutter guards have a 30×30 holes/square inch mesh. This is the perfect size, not too small, and not too large. It is small enough to keep out all debris, including pollen, pine needles, shingle grit etc., however large enough to provide maximum water flow and management into the gutter.

Can the gutter guard handle a heavy rainstorm?

The simple answer is YES! LeafBusters® Installed gutter guards are the most effective gutter guards on the market today. The scientifically designed and engineered system follows your roofline, as opposed to “other company’s” products, which lay relatively flat on the gutter. The 30×30 mesh can handle the heaviest of rains. Most, if not all, of the “other company’s” gutter guards will have either debris collecting on top, water run-off, or both.